Bauer P7 Studio

Weight: 28.8 kg
Reel Capacity : 600 m or 2,000 feet
Film lacing: On the picture film deck automatic or
manual. On the magnetic film deck, manual
Lens: P-CINE-ZOOM-16 1:1,3 / 35 - 65 mm Swiss Made
Picture Aperture: 7.16 x 9.6 mm (ace. to DIN standard 15.650 SMPTEPH 22.8)
Projection Lamp: 24 V I 250 W halogen
Light Output: About 450 lumens
Power Requirements: Built-in voltage selector for 220 and 240 V 50 Hz A.C.
Drive: Three-phase synchronous motor, permits synchronous single operation, or operation in conjunction with other studiosynchronizing equipment (such as Rotosyn), via multiple socket on the projector
Running Speed: 24 and 25 fps. can be switched mechanically, forward and reverse run
Claw: Film-saving three-tooth claw
Sprocket Coupling: Sprockets on picture film and doubleband sides are mechanically coupled.This couping can be disengaged for shifting the double-band side against the picture film side and vice versa
Rewinding : Picture film : Rapid power rewind Magnetic film: power rewind (for lorng film use separate rewinder)
Film end / Film break Switch: The projector is automatically shut off at the end of the film, and in case of operating troubles due to damaged films.
Operating Hours Counter: Built-in
Auxiliary Lighting : Built-in pilot light with switch
Amplifier: Built-in, 20 W sine, clearly arranged push buttons and rotating controls, electronic fuse, studio-type inputs and outputs, some of which are adjustable; microphone and record player inputs are separately adjustable. The speaker can be controlled during recording.
Built-in Speaker: 2 W (switch &quot0&quot, &quot half&quot, &quot full &quot)
Exciter Lamp: 6 V 1 amp., D. C.-supplied
Inputs: Phono 150 m V I 600 k ohms, Microphone 0.5 m V I 200 ohms, symmetrical , Input 1.5 V I 600 ohms, symmetrical (+ 6dB)
Outputs: Speaker 8 ohms, output 1.5 V I 600 ohms, symmetrical, (+ 6dB), Output 1.5 V I 600 ohms, symmetrical (adjustable) Output for separate control instrument contact wiring : 2-ground/3 AF (7.2 V = I 390 ohms)
Magnetic Head Assembly (double-band): Plug-in (with erase head) combination head for recording and reproduction, monitoring head, switchable from center- to edgetrack)
Monitoring (Off Tape) : On the picture film and magnetic film side can be picked up via symmetrical 1.5 V / 600 ohm output and 5-15-ohm speaker output (both outputs are adjustable), can be switched to picture film side and magnetic film side.
Magnetic fading control: Continuously adjustable for fade-in and fade-out recordings (on picture film side and on magnetic film side)
Volume Control Indicator: dB indicator instrument
Frequency Response for Optical Sound (picture film side): 40Hz ... 7 HHz ± 3 dB
Frequency Response magnetic sound: 40Hz ... 12 HHz ± 3 dB Equalization accord. to DIN-Standards
Signal-to-noise Ratio :> 45dB
Wow and Flutter (picture film side) : 0.4% (acc. to DIN standard)
Wow and Flutter (magnetic film side):0.3% (acc. to DIN standard) 
Run-up on picture film side : Maximum 5 seconds
Run-up on double-band side : Maximum 3 sec. (run-up and braking gears for flywheels)